Table des Matières
Publicité
Étiquette de sécurité
Report No. G100405039PRT-001
Control No. 4000515
Conforms to ASTM E1509-04, Room Heater Pellet Burning Type (UM) 84 HUD and UL 1482; Certified to ULC S627
Electrical Rating: 115 V, 60 Hz, 3 Amp: Start 3 Amps, Run 2.2 Amps with blower on High
Maximum Input Rating: 5.0 lbs/hr
This pellet fired appliance has been tested and listed for use in manufactured (mobile) homes in accordance with OAR 814-23-900 through 814-23-909.
WARNING - FOR MANUFACTURED HOMES: Must utilize outside combustion air inlet (part #99200136) or equivalent. Structural integrity of the manufactured home floor, ceiling and
walls must be maintained.
Install only in accordance with the manufacturer's installation and operating instructions. Contact local building or fire officials about restrictions and installation inspection in your
area. Use only 3 in. / 77 mm diameter listed type "L" or "PL" venting system. See manufacturer's installation instructions and local codes for precautions required for passing
chimney through a combustible wall or ceiling. Do not connect this appliance to a chimney flue serving another appliance. Inspect and clean exhaust venting system frequently in
accordance with manufacturer's instructions.
May be installed in a sleeping room with use of outside combustion air inlet (Part #99200136) or equivalent.
For use with 1/4 in. / 6 mm to 5/16 in. / 7 mm diameter pelletized wood fuels only.
Replace glass only with 5 mm ceramic glass available from your dealer.
DANGER: Risk of electrical shock. Disconnect power supply before servicing. Route power cord away from unit. Do not route power cord beneath heater.
Operate only with viewing door and ash removal tray tightly closed. Do not obstruct combustion air openings. The space beneath heater must not be obstructed. Keep all
furnishings away from heater.
Interior Vertical
Flue Installation
Side wall
A
6 in. / 153 mm
Rear wall
B
**
Corner
C
3 in. / 77 mm
Flue Vent
D
See Owner's Manual
Maximum alcove depth 48 in. / 1220 mm, minimum ceiling height 60 in. / 1524 mm, minimum alcove width 36-9/16 in. / 929 mm.
Combustible floor must be protected by a non-combustible material, extending to the front (E) 6 in. / 150 mm and to the sides (F) 0 in. / 0 mm.
EXCEPTIONS: Non-combustible floor protection must extend beneath a vent tee when installed.
** This dimension will vary depending on brand of listed type "L" vent. See manual for details.
U.S. ENVIRONMENTAL PROTECTION AGENCY: This model is exempt from EPA certification under 40 CFR 60.531 by definition [Wood Heater (A) "Air-to-fuel Ratio"].
2012
2013
© Travis Industries
WARNING - DO NOT REMOVE OR COVER THIS LABEL
MODEL: AGP PS
Listed Pelletized Solid Fuel Burning Appliance
Also for use in mobile homes
Certified for US and Canada
Minimum Clearance to Combustible Materials (Measured to Stove Top)
Horizontal Through
the Wall Installation
6 in. / 153 mm
A
3 in. / 77 mm
3 in. / 77 mm
F
See Owner's Manual
FLOOR PROTECTOR
DATE OF MANUFACTURE
2014
Jan.
Feb.
Mar.
Apr.
4012412
REAR WALL
CORNER
D
B
C
A
C
E
F
May
June
July
Aug.
Sep.
SERIAL NO:
Manufactured by:
4800 Harbour Pointe Blvd. SW
Mukilteo, WA 98275
www.travisproducts.com
Oct.
Nov.
Dec.
100-01270_000
37
1000
Publicité
Table des Matières
