Handling And Operation; Charging Mobile Devices With The Powerbank - SilverCrest SPB 2.600 B 1 Mode D'emploi

All manuals and user guides at all-guides.com

Handling and operation

Charging mobile devices with the
Powerbank
♦ Connect the microUSB plug of the charging cable
to the microUSB port of the mobile device and
the USB plug to the USB port
The charging process starts automatically.
♦ If charging does not start automatically, press the
ON/OFF button
process.
NOTE
► Alternatively, you can also use the original
charging cable (USB cable) provided by the
respective device manufacturer.
♦ During the charging process, the current charge
level of the Power Bank is shown via the charge
level LEDs
"Checking the charge level").
♦ To end the charging procedure, disconnect the
charging cable
the Power Bank. The charging status LEDs
off after about 15 seconds.
SPB 2.600 B1
briefly to start the charging
(see table in chapter entitled
from the mobile device and
GB
of the Powerbank.
go
53