MINN KOTA Talon Mode D'emploi page 3

Clearing Paired Talons from the Remote
The Remote was designed so that all paired Talons can be cleared from memory.
1
a. Press and hold the Up
button on the Remote at the same time until the
Talon Selection LEDs on the Remote begin to scroll,
release the buttons. The Remote will go into Pairing
Mode for 30 seconds. Once Pairing times out all
Talons will be cleared.
NOTICE:
Putting the Remote into Pairing Mode,
even if it is accidental, without Paring the Remote
to a Talon will clear all paired Talons.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Johnson
®
Outdoors Inc is under license. Other trademarks and trade names are those of their respective owners.
For warranty information, please visit www.minnkotamotors.com.
minnkotamotors.com
Part #2377176
button and the Down
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 38525
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
©2018 Johnson Outdoors Marine Electronics, Inc.
Fax (800) 527-4464
Talon Selection LEDs
Auto Up/Down
Buttons &
Pairing Button
A Johnson Outdoors Company
All rights reserved.
Rev A 04/18