Climadiff GAMME Notice D'utilisation page 51

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
The humidity level is too low
The temperature in the cellar is not consistent
The light does not work
There are three alternatives for reducing the
cellar's humidity:
Replace the charcoal filter
-
Decrease the temperature slightly inside
-
the cellar
Remove the water tray if you have added
-
one into your wine cellar
Humidity is regulated by the principle of
thermodynamics. During a cooling period, a
frost forms (cold air dries the air); humidity will
decrease. During a heating period, the frost
melts and humidity will increase
It is essential to calculate an average value
over several cycles and not from a single
reading
Humidity level can be affected by an ambient
temperature too low (rate will drop) or too high
(rate will rise). The degree of hygrometry is
optimal when the ambient temperature is
between 20°C and 25°C
To increase the humidity in the cellar, there are
two alternatives:
Place a tray inside your appliance and add
-
water into it to raise the moisture rate
Raise the temperature slightly inside the
-
cellar
The actual temperature to take into account is
the temperature in the bottle. The temporary
variations which you observe correspond to the
compressor's operating cycles
It is through this principle of a series of small
variations in the air inside your wine cellar that
a suitable average temperature is obtained,
ensuring the best conditions for maturing your
wine
Temperature variations are related to cold
cycles but are too short to change the
temperature of the wines because liquid has a
greater inertia than air. Liquid thus remains
always at the mean temperature
If the temperature noted in your wine cellar is
different from that usually seen and it does not
change continuously (over several hours),
please contact your retailer's after-sales service
If ambient temperature is very low, the
temperature obtained may be slightly below the
set temperature. If winter system is operating,
the cellar automatically switches to mono-
temperature mode to guarantee the good
preservation of your wines
Not plugged in
The circuit breaker tripped or a blown fuse
The bulb has burned out, contact your after-
sales service
51

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gamme pro

Table des Matières