Samsung DW80R9950 Serie Manuel D'installation page 20

Installation
STEP 7 Placing the dishwasher and connecting the hot water supply line
1. Adjust the three leveling legs at the bottom of the dishwasher after measuring the
height of the cabinet opening from under the countertop to the floor. (See STEP 8,
Leveling the Dishwasher.)
2. Locate the hot water supply line and the power cable.
3. Place the dishwasher so that the hot water supply line is in the left side and the power
cable is in the right channel of the base of the dishwasher. The right-side channel for
the power cable has a built-in hook on the base so that you secure the power cable.
4. Pull the drain hose through the hole in the sink cabinet side wall. Keep it free of kinks.
5. Make sure the hot water supply line is not twisted, and then connect the hot water
supply line to the fitting joint.
6. Slide the dishwasher carefully into the installation space. If possible, gently pull any
excess lengths of water supply line, drain hose, or power cable back as you move the
dishwasher. Get a second or third person to help you do this if necessary.
CAUTION
Do not place the dishwasher on the water supply line, drain hose, or power cable. Also,
make sure they are not folded or twisted.
• Make sure the supply line is properly connected.
Wrap Teflon tape around every connection to prevent water leaks.
Make sure the side gaskets are inserted seamlessly. Otherwise, it may increase noise
when the dishwasher is operating.
• Make sure both side gaskets are
end of the kitchen cabinet. Less distance may increase noise when the dishwasher is
operating.
20 English
DW9900R_DD68-00208B-00_EN.indd 20
/ " to 1" (20-25 mm) backward from the front
13
16
12/29/2018 1:57:43 PM