Blueant V1 Mode D'emploi page 16

BlueAnt
Basic Headset Functions
For easy reference, also see the Button/Function Matrix and the Quick Start Guide.
1. Power ON: Press and Hold the BAB
will be displayed. After powering ON, your headset will automatically connect to your last used phone if it is in operating
range. If this phone is not range, the V1 will enter idle mode after 60 seconds. If no phone has yet been Paired, it will enter
the welcome prompt.
2. Power OFF: Press and Hold the BAB
Idle mode.
3. Enter Pairing Mode: With the V1 OFF, Press and Hold the BAB
stay in pairing mode for 2 minutes then will go into idle mode. To re-enter pairing mode, repeat this step, or say "Pair Me"
4. Make a Call: Dial the number using your phones keypad as normal. Audio will automatically transfer to the headset.
5. To Answer a call: Click the BAB
6. To End a call: Double Click the BAB
7. Reject: Double Click the BAB
8. Redial the last call : Press and Hold Vol
9. Activate Phone Commands (Voice Dialling)*: While connected to a phone, press the BAB
have been previously recorded into your phone (see your phones user guide for specifi c instructions. (Button Only Mode)
10. Reconnect: To reconnect your phone to the V1, simply turn the V1 ON. Or if already powered ON, Click Volume
Volume together. Alternatively, you can use the menu of your Bluetooth phone.
16
All manuals and user guides at all-guides.com
for 3 seconds. The solid Blue LED will light up. If the battery is low a solid Red LED
for 3 seconds. The Red LED fl ashes three times. Power Off works on Standby/
once when there is an incoming call.
to end the call.
to reject an incoming call.
for about 3 seconds. To cancel Redial, click the BAB
for about 6 seconds until the LED fl ashes Blue. The V1 will
once. Voice commands must
and