Fcc Statement - GE Profile P7CEBBS6RBB Mode D'emploi

FCC/IC COMPLIANCE STATEMENT
FCC/IC COMPLIANCE STATEMENT:
following two conditions:
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE:
are designed to provide reasonable protection against harmful interference in
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
that may cause undesired operation of the device.
Labeling: Changes or modifications to this machine not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
ConnectPlus
RF Exposure
20 cm of separation distance between the ConnectPlus device and the user's body
must be maintained at all times.
FCC ID:
IC ID:
22