Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.4. E
LECTROLYTIC SOLUTIONS INSTALLATION
Pay attention: use adequate protective devices such as gloves and goggles (chapter 2).
Pay attention:
verify that you are using the electrolytic solution correct for the desired operation:
Neutral Bomar (24a) weld-cleaning solution.
Tig Bomar (24b)
Brill Bomar (24c)
1. Unscrew the tube tank cup (24) and remove the protection film.
2. Do not to turn the tube (24) over. Connect it to the torch (23) and fix it by screwing the ring nut (Picture K6).
5.5. W
-
ORK
PROCESS SELECTION
Put the knob (10) on the function you selected for the small torch (23):
Cleaning
Setting
Solutions
Neutral Bomar (24a)
AC
Tig Bomar (24b)
Brill Bomar (24c)
Polishing
Setting
Solutions
DC
Brill Bomar (24c)
Notes:
(*)
CLINOX BRUSH is ideal for inside corners and hard to reach areas.
(**) The graphite insert Big 35mm and its Big Bond pad are not supplied with Clean&Brill Kit.
5.6. P
OWER REGULATION
Cleaning
Setting
Narrow inserts (27 b/d)
Large inserts (27 a/c)
AC
CLINOX BRUSH (32)*
Big insert 35mm (27e)**
Polishing
Setting
Narrow inserts (27 b/d)
Large inserts (27 a/c)
DC
CLINOX BRUSH (32)*
Big insert 35mm (27e)
Notes:
(*)
CLINOX BRUSH is ideal for inside corners and hard to reach areas.
(**) The graphite insert Big 35mm and its Big Bond pad are not supplied with Clean&Brill Kit.
CLINOX POWER
weld-cleaning solution.
weld-polishing solution.
(operating knob - 10)
Graphite inserts (27)
CLINOX BRUSH (32)*
Graphite insert Big 35mm** (27e)
Graphite inserts (27)
CLINOX BRUSH (32)*
Graphite insert Big 35mm** (27e)
(power knob - 11)
Inserts
Narrow pads (28 b/d)
Large pads (28 a/c)
-
+ Big Bond pad 35mm (28e)
Inserts
Narrow pads (28 b/d)
Large pads (28 a/c)
-
Big Bond pad 35mm (28e)
Inserts
Tig Bond pads (28)
-
Big Bond pads 35mm**
Inserts
Tig Bond pads (28)
-
Big Bond pads 35mm**
Pads
Pads
40
Pads
(28e)
Pads
(28e)
Power regulation
1
2
3
4
1
2
3
4
Publicité
Table des Matières
