R&G RGH0004BK Instructions De Montage page 2

Page | 2
FITTING INSTRUCTIONS

UNCLIP AND REMOVE THE SPRING CLIP SHOWN IN PICTURE 1.

UNDO AND REMOVE THE THREE BOLTS ARROWED IN PICTURE 2.

REMOVE CHAIN GUARD.

CLEAN THE SWING ARM WHERE THE HUGGER WILL CONTACT.

PEEL THE BACKING FROM THE VELCRO PATCHES AND STICK TO THE SWING ARM
IN POSITION TO MATCH THE PATCHES ON THE HUGGER.

UNDO AND REMOVE THE BRAKELINE GUIDE ON THE RIGHT HAND SIDE (YOU MAY
CUT THIS OFF OR UNDO THE BRAKELINE CONNECTOR WHICH WILL MEAN THE
BRAKE SYSTEM HAS TO BE BLED).

OFFER THE HUGGER INTO POSITION.

FIT THE CHAIN GUARD OVER THE HUGGER AND REFIT THE SPRING CLIP AS
ORIGINAL (SHOWN IN PICTURE 1).

USE THE P-CLIP (ON THE BRAKELINE) FROM KIT AND THE SHORTER BUTTON
HEADED BOLT WITH THE SMALLER WASHER INTO THE ORIGINAL MOUNTING ON
THE RIGHT HAND SIDE; DO NOT TIGHTEN AT THIS STAGE AS SHOWN IN PICTURE 3.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301

PICTURE 1
PICTURE 3
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
PHILLIPS DRIVER.
R&G Racing
www.rg-racing.com Email:
B
A
PICTURE 2
info@rg-racing.com
C