Technical Data; Installation Instructions - Franke PESCARA PULL DOWN FF4700 Manuel D'installation

EN

Technical data

Operating data
Operating pressure (ideal)
Operating pressure (max.)*
Operating pressure (min.)*
Water temperature (ideal)
Water temperature (max.)
Hole Size For Faucet
Certifies this faucet complies with ASME A112.18.1 / CSA B125.1 & NSF 61, NSF 372 and
AB1953. The faucet also complies with water usage requirements of the California
Energy Comission and the US Department of Energy.

INSTALLATION INSTRUCTIONS

1. Remove all contents from the package
and check for completeness.
2. Turn off water supply.
3. Cut a mounting hole 1 3/8" diameter
(35mm) in the desired mounting surface
(if one isn't available).
4. Ensure Base O-ring (2) is in place in the
Faucet Base (1) (fig. 2A).
2A
1
2
5. Insert the faucet into the hole, hoses
first (fig. 2B)
ATTENTION: Base-O-Ring (2) should be
sitting between the countertop and faucet
base.
DO NOT use putty or other sealant at this
location.
NOTES: Solid surface installation: The
countertop mounting surface needs to be
Value
45 PSI 3 bar 300 kPa
70 PSI 5 bar 500 kPa
14.5 PSI 1 bar 100 kPa
140°F 60°C
158°F 70°C
1 3/8 " 35mm
flat and free of debris; otherwise the faucet
may not sit properly and could leak.
2B
– 4 –
3
4
5
6