out, power transmission isn't
optimal)
Gearbox overheated
Oil loss from gearbox
Machine has Machine has high
wear and tear
Break off / bend parts
Pulleys not correct in line
Cutting height too low adjusted
Oil level low
Oil too old
Flail rotor / machine is
overloaded
Oil seal(s) damaged / worn out
Cutting height too low adjusted
No original parts – vibrations in
machine
Machine is involved in a collision
or damaged by pollution
115
Align the pulleys correctly
Check rear roller adjustment and
change that when necessary
Olie tot pijp aanvullen
Tandwielkast reinigen en olie
verversen
Slow down speed and or check rear
roller adjustment
Change oil seal(s)
Check rear roller adjustment and
change that when necessary
Fit original Perfect parts
Change defect parts and when
necessary must the flail rotor
balanced