Publicité
Les langues disponibles
Les langues disponibles
1.10 Service
Before operating the machine you should check if all points, as stated below, have been greased properly. Lubricate as
follows:
1.10.1 P.T.O. shaft
Profile tubes:
-
to lubricate every 24 hours of operation. Wash them clean
periodically in order to remove dirt and accumulated contaminated
grease.
Yoke crosses:
to lubricate every 8 hours of operation.
Slide pins:
to oil at regular times the pin.
1.10.2 Overloading clutch P.T.O. shaft
To ensure correct functioning, friction clutches must be relieved prior to first time use and after lengthy periods of non-
use. To this end, the friction linings must be relieved of pressure and the clutch turned manually.
Notes on relieving of Type K96:
• Uniformly tighten the nuts No. 3, thereby relieving the pressure on the friction disks.
• Turn the clutch.
• Subsequently unscrew the nuts No. 4 again up to the end of the thread.
1.10.3 Bearing houses / rotor shaft
To be lubricate every 8 hours of operation.
1.10.4 Rear roller
To be lubricate every 8 hours of operation
If possible lubricate with Total Lical EP/ ELF EPEXELF 2 or an equivalent grease.
Viscosity base oil 40°C 190 - 220 Cst.
Thickener Lithium/Calcium compatible.
Temperature range -25°C tot 130°C
Good pressure properties.
112
Publicité
Chapitres
