Before First Use; Making Espresso - Klarstein LIBEICA Mode D'emploi

EN
22

BEFORE FIRST USE

1. Remove the appliance from the packaging and check that all of the contents
are there.
2. Clean all removable accessories.
3. Use the machine as described in the sections 'Making espresso' and 'Making
cappuccino' (without coffee powder in the filter). Repeat this 2-3 times.
4. Remove the red silicone cap from the water tank before using the machine.

MAKING ESPRESSO

For example for 2 cups
1. Open the cover and remove the water tank. Fill the water tank with water up
to the maximum mark. Make sure that the water level does not exceed the
maximum mark.
2. Put the water tank back into the appliance and close the cover.
3. Plug the power plug into the mains socket. The appliance performs a self-test.
The control panel lights up first and then goes out. The power indicator lights
up red continuously. Press the on/off button. The cup indicator lights flash
red, the steam button lights up red continuously and the appliance heats
up. After about one minute, both button indicators light up red, the steam
indicator lights up red and preheating is complete.
4. Remove the filter holder and use the coffee spoon to put the appropriate
amount of coffee (15-17 grams) into the filter. Press the coffee down firmly.
Remove excess coffee powder from the rim to avoid damaging the sealing
ring of the brew group head.
Note: If too much coffee powder remains on the edge of the filter, this can lead
to an insufficient seal and water leaking out.
Water tank
Red silicone cap