Roco geoLINE Manuel D'instructions page 17

Installation of the electrical drive 61195
The points actuator is placed into the bed of the points and attached with screws. The setting
catch for manual operation must be installed in accordance with the respective installation pla-
ce. The setting catch can be pulled out and pushed in again at the opposite side of the setting
lever if necessary.
8051250920.indd 17
The electrical actuator has a double coil system with a
limit stop switch. The limit stop of the points actuator
prevents the presence of any voltage at the respective
coil after the setting procedure has been completed,
thus avoiding damage.
GB
17
18.06.2013 08:54:05