CASUALPLAY base fix Baby Instructions page 14

• Lastly, adjust the length of the support bar by pressing the adjustment button of the
support bar (fig. 6) and unfold it until it touches the floor of the vehicle (fig. 7). A green
indicator will appear on the support bar when it is fitted correctly (fig. 8).
• Check that the support bar is locked into place and that it does not move upwards or
downwards.
WARNING: Check that the support bar is correctly set to one of the adjustment positions.
Fitting the Base Fix Baby 0+
• Put the handle of the Base Fix Baby 0+ into the carrying position.
• Position the Base Fix Baby 0+ facing backwards, place it on the fastening points of the
base.
• Press the Base Fix Baby 0+ against the base until it clicks and two green indicators will
appear on the front part of the base (fig. 9).
• Check that it is securely fastened to the base by pulling the Base Fix Baby 0+
upwards.
• Detaching the Base Fix Baby 0+
• Pull the release device found on the backrest of the Base Fix Baby 0+. The indicators on
the front part of the Base Fix Baby 0+ will turn red, indicating that it has been detached
correctly (fig. 10).
• Pull the seat upwards (fig. 11).
• Detaching the base
Remove the Base Fix Baby 0+ car seat.
• Pull the buttons on both sides of the connectors. A red signal will appear if this has been
done correctly (fig. 12).
• Remove the base from the seat.
• Fold the support bar over the lower part and fasten it.
Maintenance
• Clean the plastic parts of the base using a cloth with soap and warm water. Do not use
abrasive cleaning products or solvents.
12