Heath Zenith SL-3362-00 Mode D'emploi page 13

• Move a jumper on the chime from one location to another. Move the corresponding jumper on the push button or set the matching
two dip switches on the push button to match the jumper settings on the chime.
Example 1: Move jumper at location "5" to location "4" on both the push button and the chime.
Example 2: In the chime, move the chime jumper at location "5" to location "4". In the push button, set the "5" dip switch to OFF
and the "4" dip switch to ON.
Note: Code positions 1 through 7 must be exactly the same for both the push button and chime for this system to function.
Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the push button and on the chime or dip switches 5, 6, and 7
in the ON position (see Figure 12).
The range of the wireless chime can vary with location, temperature, and battery condition.
7 6 5 4 3 2 1
TUNE SELECT
Front of Chime Base
* Code Settings 1-7 Must Match Both Push Button and Chime
UP
1 2 3 4 5 678
Inside Push Button
Using Jumpers
Figure 12
-13-
Note: Some models might
require the use of tweezers
to remove and replace the
jumpers or a small screw
driver to set dip switches.
Inside Push Button
Using Dip Switches
598-1377-01