Heath Zenith SL-3362-00 Mode D'emploi page 10

Wireless Push Buttons
The factory setting for all wireless push buttons is for the front door
tune selection. This tune can be changed by following the instructions
below (see Figure 9).
1. Determine where each (if using more than one) push button
will be used.
2. To set push button for front door tune: Open push button. Loca-
tion 8, set dip switch OFF (0 or Low) or remove jumper.
3. To set push button for rear door tune: Open push button. Loca-
tion 8, set dip switch ON (1 or High) or add jumper.
Install ChImE CovER
The base is designed to sound an alert if the cover is not installed
properly onto the base. As such, it is important to install the cover
correctly. The cover rotates on and off of the base very much like
a door swings on its hinges. Follow the steps below to install the
cover onto the base.
1. Align the wide tab on the cover with the wide slot on the base
and the narrow tab on the cover with the narrow slot on the base
(see Figure 10).
2. Insert tabs into slots and rotate cover onto base (see Figure 10).
The cover will snap into place and should fit flush against the
wall when properly installed.
-10-
Orientation Markings
Wide Slot
Chime
Base
Narrow Slot
Note: Never use cleaners or polishes. Never use any fluids on the
electronic chime mechanism. Use dry cloth to clean chime cover
and base.
Figure 10
598-1377-01
Wide Tab
Back of
Chime
Cover
Narrow Tab