Cleaning The Car Seat Covers; How To Remove The Car Seat Covers; How To Install The Car Seat Covers - APRAMO METTRO Mode D'emploi

The two tongues are released very slow when the red button is
pressed.
The two tongues do not engage in the buckle's body and are
ejected when you try to insert them in.
The tongues are inserted into the buckle's body, but without the 'click'
sound signal.
The two tongues are inserted with difficulty and the buckle's body
offers a certain resistance.
The buckle needs a lot of force to open.
Normally, a rinse with warm running water is enough to solve the
problem. If not, contact the seller or the manufacturer immediately.

7.2 Cleaning the car seat covers

The car seat covers are removable and washable. Please carefully
refer to the washing label, sewn internally in the cover.

7.3 How to remove the car seat covers

1) Adjust the headrest in the highest position.
2) Remove the headrest cover.
3) Remove the remaining covers from the car seat.

7.4 How to install the car seat covers

1) Repeat the previous steps in reverse order.
2) Carefully insert the outer edge of the cover along its entire perimeter,
using, if necessary, the tool provided.
GB 10 FR 10
WARNING! DO NOT USE THE CHILD CAR SEAT WITHOUT THE
COVERS OR WITH COVERS OTHER THAN THE ORIGINAL. A
DIFFERENT COVER COULD REDUCE THE SAFETY LEVEL, IN THE
EVENT OF AN ACCIDENT.
WARNING! ALWAYS MAKE SURE THAT THE COVERS AND
HARNESS STRAPS OF THE CAR SEAT ARE INSTALLED CORRECTLY.
IN CASE OF DOUBT, CONTACT THE MANUFACTURER OR
DISTRIBUTOR FOR ADVICE.