Changing Operating Modes - EYENIMAL Small Bark Control Guide D'utilisation

− remove the collar from the charging station
− disconnect the charger for the wall outlet
A full charge takes approximately 2 hours.
Activate/Deactivate the collar
Activate: move the magnetic key towards
the collar so that it comes into contact
with the
Diagram 3). A Beep sound will be emitted
and the indicator light will flash in green (1
flash every 5 seconds) indicating that the
collar has been switched on.
Deactivate: move the magnetic key towards
the collar so that it comes into contact with the
Two beep sounds will be emitted and the indicator light will flash in red twice and then off
indicating the collar has been switched off.
To increase the battery life, we recommend you to deactivate the collar if you are not using
it for a long period.
Operation
At the first bark, a serie of six beeps is emitted. If another bark is detected within 30 seconds,
another beep sound of 2 seconds is emitted together with a static stimulation (progressive
stimulation for stimulation for sensitive dog or progressive stimulation for difficult dog
according to the selected operating mode).
Inhibition of any further stimulation is dependent on the absence of any barking within the next
30 seconds.
The stimulation function can be inhibited selecting operating mode Nr 1. In this case, only beep
sounds will be emitted.
After being activated 9 times in quick succession, the collar will automatically go into safety
mode for 2 minutes before restarting itself normally.

Changing operating modes

In the factory, the collar is set to mode Nr 2 (beep sound + progressive stimulation for sensitive dog).
To change the collar's mode, proceed in the following way:
- When switching on the collar, keep the magnetic key in contact with the
enimal_Small_Bark_Control-fr.indd 16
symbol, hold for 1 second (See
symbol, hold for 1 second (See Diagram 3).
Gb - 16
Diagram 3
symbol on the front
25/07/2016 15:3