inventiv 202108 Notice D'instruction D'origine page 26

202108 PLANER 900W
blades.
Press the safety cover down with your finger. Push the
blade out with the tip of a spanner (or a screwdriver)
and then remove.
NOTE: There is no need to remove the blade clamp as
this will change the factory settings for cutting blade
height control.
NOTE: If a blade cannot be pushed out easily after
loosening the screws, use a piece of wood to break the
blade loose from the blade clamp, with a short sharp
blow. Then push with a screwdriver to remove the
blades. If necessary, tap the piece of wood sharply with
a small hammer to break the blades loose.
Before reinserting a new or reverse blade, always clean
both the blade and the blade seat if dirty. Slide the
blade into the clamp with a spanner (or a screwdriver)
in the correct orientation. Check the blade is equal with
the clamp. Retighten the three blade screws with the
spanner.
Repeat the above procedure to change the other blade.
After the blades are replaced, check if the blades are
parallel and in the same surface as the rear base plate
with a ruler. If not, you can adjust the blades with the
hexagonal wrench provided. Firstly loosen the three
screws on the blade clamp. Turn the socket head screw
clockwise, the blade will be risen. Turn it anticlockwise,
the blade will be lowered down. Finally retighten the
three screws fully.
10. REPLACING A DRIVE BELT (See Fig. N, O)
WARNING:
1. Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
2. The cutting blades will be turning and may cause
injury.
3. Always put on gloves when operation.
Loosen the screws and remove the belt cover. Remove
the worn drive belt from the large pulley and the pinion
and clean them. Lace the new belt on the top of the
pinion and turn it manually, press it on the large pulley.
Make sure that the drive belt runs exactly along the
length grooves of the pinion and the pulley. Replace the
belt cover. Install the cover screw and tighten fully.
26
SAFETY AND OPERATING MANUAL