inventiv 202108 Notice D'instruction D'origine page 24

202108 PLANER 900W
4. EDGE CHAMFERING (See Fig. D, E)
CAUTION: Always use both hands on the tool for
any operation. It assures to maintain control and avoid
the risk of serious personal injury. The workpiece must
always be properly supported and clamped so that both
hands will be free to control the planer.
Using the V-groove (9) in the base plate you can make a
chamfer on the work piece edge. Guide the planer along
the edge and maintain a constant angle and force to
produce a good finish. You can control the angle of the
chamfer with your hands. Make a test chamfer on a scrap
piece of wood. Maintain downward pressure to keep
your planer flat at the beginning and the end of the work
surface.
45
o
5. USING THE PARALLEL GUIDE (See Fig. F)
Insert the screw provided through the hole on the
support of parallel guide (7). Turn the screw into the nut
on the housing. Fix the parallel guide on the support
of parallel guide with the screw and nut. Ensure the
screws are tightened securely.
NOTE: The parallel guide should be fitted on the left of
housing.
To adjust the required width of cut, loosen the nut
and slide the parallel guide to the required position.
Retighten the nut fully.
Use the parallel guide while cutting. The guide should
be held firmly against the edge of the workpiece.
6. USING THE REBATE (See Fig. G)
Insert the screw(11) provided through the slot on the
Rebate. Turn the screw into the nut on the housing.
The cut depth adjustment can be set from 0 to 10mm.
To adjust the depth of cut, place the planer on a flat
board, then loosen the screw and slide the cut depth
adjustment guide up and down for required depth.
Tighten the thumb screw fully.
7. REBATING (See Fig. H)
The width of rebating cut (a) is adjustable by moving
the parallel guide. The depth of rebating cut (b) is
24
SAFETY AND OPERATING MANUAL