inventiv 202108 Notice D'instruction D'origine page 23

202108 PLANER 900W
OPERATING INSTRUCTIONS
Note: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for planing of firmly supported
wooden materials, such as beams and boards. It is also
suitable for beveling edges and rebating.
1. SAFETY ON/OFF SWITCH (See Fig. A)
The switch is locked off to prevent accidental starting.
Depress the lock off button then the on/off switch and
release the lock off button. The machine is working now.
To switch off, just release the on/off switch.
WARNING: Danger of kickback! Apply the machine
to the work piece only when switched on.
2. CUTTING DEPTH ADJUSTMENT (See Fig. B)
The planing depth can be adjusted from 0 to 3mm.
Rotate the cutting depth adjustment knob (13) to set
the required cutting depth with the scale (12). The
clockwise rotation increases the planing depth; the
anticlockwise rotation reduces the planing depth.
Always work from a rough cut to a finish cut.
It is recommended that test cuts be made in scrap
wood after each adjustment to make sure that desired
amount of wood is being removed by your planer.
NOTE: To protect blades during storage, transporting,
etc., set blade depth adjustment knob to 0.
3. STANDARD SURFACE PLANING (See Fig. C)
Set the desired cutting depth. Position the front part
of the base plate flat onto the work surface. Make sure
that the blades are not touching the workpiece. Switch
the machine on and push your planer forward and it
will start cutting. Always maintain all of the base plate
flat on the work surface to prevent the cutting blade
jumping. Move the plane evenly over the work surface.
Be careful to avoid hitting nails during operation. It
could nick, crack, or damage blades. We suggest that
you always keep an extra set of blades on hand for
replacement.
23
SAFETY AND OPERATING MANUAL