MSI GF615M-P31 Mode D'emploi page 23

aMd Cool'n'quiet
the Cool'n'quiet technology can effectively and dynamically lower CPu speed
and power consumption.
iMPoRtant
to ensure that Cool'n'quiet function is acti-
vated and will be working properly, it is re-
quired to double confirm that:
* Run BioS Setup, and select Cell Menu.
under Cell Menu, find aMd Cool'n'quiet,
and set this item to "enabled".
enter Windows, and select [Start]->[Set-
*
tings]->[Control Panel]->[Power options].
enter Power options Properties tag, and
select Minimal Power Management under
Power schemes.
adjust CPu FSB Frequency (MHz)
this item allows you to adjust the CPu FSB frequency.
adjust CPu Ratio
this item is used to adjust CPu clock multiplier (ratio). it is available only when the
processor supports this function.
adjusted CPu Frequency (MHz)
it shows the adjusted CPu frequency (FSB x Ratio). Read-only.
Memory-Z
Press <enter> to enter the sub-menu.
diMM~2 Memory SPd information
Press <enter> to enter the sub-menu. this sub-menu displays the information
of installed memory.
advance dRaM Configuration
Press <enter> to enter the sub-menu.
dRaM timing Mode
this field has the capacity to automatically detect the dRaM timing. if you set
this field to [dCt 0], [dCt ] or [Both], some fields will appear and selectable.
dCt 0 controls channel a and dCt controls channel B.
t/2t Memory timing
When the dRaM timing Mode is set to [Manual], the field is adjustable. this
field controls the command rate. Selecting [t] makes dRaM signal controller
to run at  clock cycle rate. Selecting [2t] makes dRaM signal controller run
at 2 clock cycles rate.
MS-7597
23