Data Menu - Counter Display And Zeroing; How To Access The Programming Mode - LaCimbali M34 SELECTRON Utilisation Et Installation

Counters are displayed by pressing the
The following message appears on the display (5):
COUNTERS MENU
N° coffee gr. 1
N° coffee gr. 2
N° coffee gr. 3
N° water
N° steam
Parameters calculated are:
- N. coffee (number of coffee beverages)
- N. water (number of times water is dispensed)
- N. steam (number of times steam is dispensed using
the steam button)
- N. steam TS (number of times steam is dispensed
using the turbosteam function)
N.B. ONLY if the item "Customer Progr." is set on "YES"
and the item "Program. block" is set on "NO".
To access programming press the
following message will appear on the display:
CUSTOMER PROG.
KEY MENU
Press one of the dispensing keys on the selection panel
(2
Use the "+" (30) and "-" (31) keys to position the cursor
(black line) on the desired line, then press the
key (29).
Always use the "+" (30) and
2) exit the menu and leave the settings unchanged by
pressing the "RES" key (24).

21. DATA menu - Counter display and zeroing

(27) key.
+
01234
01234
01234
01234
01234

22. How to access the programming mode

"PRG" key (29
"PRG"
"-" (31) keys to change
key
- N. steam + air TS (number of times steam and air are
dispensed using the turbosteam function)
- N. tot coffee (total number of coffee beverages).
Counters can be zeroed by aligning the cursor on the
selected entry, pressing the
pressing the "+" (30) or
Press the "RES" key (24
The "N. coffee" entry appears for as many times as there
are machine groups.
Note: Parameters that cannot be zeroed are:
- N. tot coffee
Press the "RES" key (24) to return to the main menu.
Note: When modifying data, the cursor changes to "
a slide bar with maximum and minimum settings will appear:
MM1 cof. dose
-5
-
If the "Customer Progr." is set to "NO", the following
message will appear on the display:
CUSTOMER PROG.
NOT ENABLED!
24 EN
"PRG" key (29), and then
"-" (31) key.
064
064 +5
+
", or