Wall Mounting - Black & Decker FD1620 Traduction Des Instructions D'origine

ENGLISH
FW1620 Wall Fan
Features
1. Front guard
2. Blade cap
3. Fan blade
4. Guard nut
5. Rear Guard
6. Fan Unit
7. Guard Screw
8. Speed Pull Cord
9. Oscillation Pull Cord
10. Wall mount bracket
11. Wall screw
12. Wall plugs
Assembly
Note: Make sure your fan is switched off before connecting
to or disconnecting from power supply.
Warning! Never use the fan without the guard in place or if
the guard is damaged.

Wall mounting

When fixing to a wall,make sure that the fixing method is
suitable for the wall type and is appropriate to the weight of
the fan.
Warning! Before drilling into walls, check for the location of
wiring and pipes.
• Mark the location of the screw holes(within reach of an
electrical outlet).
• Secure the wall mount bracket using screws and wall
plugs.
• Hang the fan on the wall by placing the wall mount
bracket into the screw.
• The fan should installed so that the blades are more
than 2.3m above the floor.
Fitting the fan blade and guard
• Remove the guard nut from the motor shaft by turning it
anti-clockwise.
• Place the rear guard by positioning it on the location
pins on the fan unit. Ensure that the rear guard is in the
correct orientation.
• Secure the guard on to the fan unit by re-fitting the
guard nut. Tighten the guard nut by turning it clockwise.
• Secure the fan blade on the motor shaft by fitting the
blade cap. Tighten the blade cap by turning it
anti-clockwise.
• Place the front guard onto the rear guard by positioning
the top clip on the uppermost part of the rear guard.
Push the top clip down and press the rim of the front
guard onto the rear guard ensuring a tight fit all the way
round.
6
(Original instructions)
• Close the bottom clip. Tighten the bottom clip screw by
turning it clockwise.
Use
Warning! Never use the fan without the guard in place or if
the guard is damaged.
Switching on and off
• Your fan has three speed control to keep the desired air
flow through your room.
• 0 - Off
• 1 - Low
• 2 - Medium
• 3 - High
• To switch on, turn the knob to the desired speed. The fan
will start.
• To switch off, turn the knob to the " 0 " button.
• The speed can also be adjusted by pulling the right hand
cord. Each pull of the cord will advance the speed by one
setting until the fan returns to the off position.
Oscillation
The fan can oscillate when in use to circulate air around a
greater area.
• Pull the left hand cord to start oscillation.
• Pull the left hand cord again to stop oscillation.
Adjusting the angle of the fan
• The angle of the fan can be adjusted up and down.
• Hold the fan unit and tilt the head of the fan to the desired
angle.
FS1620 Pedestal Fan
Features
1. Front Guard
2. Blade Cap
3. Fan Blade
4. Guard Nut
5. Rear Guard
6. Fan Head
7. Oscillating Knob
8. Guard Screw
9. Fan unit
10. Set Screw
11. Support Tube
12. Base Cover
13. Round Base
14. Base
15. Washer
16. Screw