Electrical Safety - Black & Decker FD1620 Traduction Des Instructions D'origine

Electrical safety

Before use, check that the mains voltage corresponds to the
voltage on the rating plate.
This appliance is double insulated in accordance
with EN 60335; therefore no earth wire is required.
• Appliance plugs must match the outlet. Never modify the
plug in any way.
• Do not use any adapter plugs with earthed (Class 1)
appliances. Unmodified plugs and matching outlets will
reduce the risk of electric shock.
• To avoid the risk of electric shock, do not immerse the
cord, plug or appliance in water or other liquid.
Mains plug replacement
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the new
plug.
• Connect the blue lead to the neutral terminal.
• If the product is class I (earthed), connect the
green/yellow lead to the earth terminal
Note! If your product is class II double insulated (only 2
wires in the cord set), no connection is to be made to the
earth terminal. Follow the fitting instructions supplied with
good quality plugs.
Any replacement fuse must be of the same rating as the
original fuse supplied with the product.
Warning! The above section on mains plug replacement is
for authorized service centre persons.
FD1620 Desk Fan
Features
1. Front guard
2. Blade cap
3. Fan blade
4. Guard nut
5. Rear guard
6. Fan head
7. Oscillating knob
8. Guard screw
9. Fan unit
10. Base
11. Screw
Assembly
Note: Make sure your fan is switched off before connecting
to or disconnecting frompower supply.
(Original instructions)
Warning! Never use the fan without the guard in place or if
the guard is damaged.
Fitting the fan to the base
• Remove four screws(10) from the fan unit.
• Insert the fan unit into the base, re-fit the four screw into
the fan unit.
Fitting the fan blade and guard
• Remove the guard nut from the motor shaft by turning it
anti-clockwise.
• Place the rear guard by positioning it on the location pins
on the fan unit. Ensure that the rear guard is in the
correct orientation.
• Secure the guard on to the fan unit by re-fitting the guard
nut. Tighten the guard nut by turning it clockwise.
• Secure the fan blade on the motor shaft by fitting the
blade cap. Tighten the blade cap by turning it
anti-clockwise.
• Place the front guard onto the rear guard by positioning
the top clip on the uppermost part of the rear guard. Push
the top clip down and press the rim of the front guard
onto the rear guard ensuring a tight fit all the way round.
• Close the bottom clip. Tighten the bottom clip screw by
turning it clockwise.
Use
Warning! Never use the fan without the guard in place or if
the guard is damaged.
Switching on and off
• Your fan has three speed control to keep the desired air
flow through your room.
• 0 - Off
• 1 - Low
• 2 - Medium
• 3 - High
• To switch on, press the button to set the desired speed.
The fan will start.
• To switch off, press the " 0 " button.
Oscillation
• The fan can be set to oscillate by pushing Oscillating
Knob downwards.To stop the oscillating feature, pull up
the Oscillation Knob.
Adjusting the angle of the fan
The angle of the fan can be adjusted up and down.
• Tilt the head of the fan to the desired angle.
ENGLISH
5