Cleaning And Maintenance; Troubleshooting - Waeco DIY-12 Notice D'utilisation

DIY-12.book Seite 40 Freitag, 24. Februar 2006 3:51 15

Cleaning and maintenance

10.4 Selecting the siren sound
You can choose one of eight different sounds for the siren.
➤ Disarm the alarm system.
➤ Switch the ignition on and off five times.
➤ Switch on the ignition again within eight seconds.
✓ The alarm siren sound a signals after eight seconds.
✓ You are now in siren sound setup mode.
➤ Press the P button to switch to a different siren sound.
✓ The siren demonstrates the new sound.
➤ If you want to change the siren sound, press the P button again.
➤ Press the ON/OFF button to save the current siren sound.
✓ The siren sound is saved.
11 Cleaning and maintenance
Caution
Do not use sharp or hard objects to clean the device as these may
damage the components.
12

Troubleshooting

The range of the remote control is decreasing.
The batteries are flat.
You have lost the remote control or it has been damaged.
➤ Switch the alarm system off using the ignition (see "Disarming the alarm
system" on page 36).
40
DIY-12