Electrical Connections - Waeco DIY-12 Notice D'utilisation

DIY-12.book Seite 31 Freitag, 24. Februar 2006 3:51 15
DIY-12
6.3 Installing the bonnet contact switch (optional
accessory)
This switch is available as an accessory.
Caution
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Find a suitable location in the engine compartment and drill a hole with a
diameter of 8 mm.
➤ During installation make sure the distance to the closed bonnet is
between 22 mm and 27 mm.
Use putty to check this distance.
You can further reduce the minimum distance by shortening the switch.
➤ Test the switch function after installation.
7

Electrical connections

7.1 Laying cables
Caution
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Note
As far as possible, use original ducts for laying the cables, or other
suitable options such as panelling edges, ventilation grilles or
dummy plugs. If there is no rubber plug, make a suitable hole with
a diameter of around 13 mm and insert a cable sleeve.
Note
Cables and connections which are not properly installed will cause
malfunctions or damage to components. Correct installation of
cables and connections ensures lasting and trouble-free operation
of the retrofitted components.
Electrical connections
31