Bestway Steel Pro MAX Manuel Du Propriétaire page 11

Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal injury
and/or damage to personal property and will void the warranty and prevent
any service claims.
• Sand should not be used to create a level base; the ground must be dug out
if necessary.
• Directly under overhead power lines or trees. Be sure the location does not
contain underground utility pipes, lines or cables of any kind.
• Do not set up the pool on driveways, decks, platforms, gravel or asphalt
surfaces. The selected location should be firm enough to withstand the
pressure of the water; Mud, sand, soft / loose soil or tar are not suitable.
• Grass or other vegetation under the pool will die and may cause odors and
slime to develop, therefore we recommend removing all grass from the
selected pool location.
• Avoid areas prone to aggressive plant and weed species that may grow
through the liner.
NOTE:
Check with your local city council for by-laws relating to
fencing, barriers, lighting and safety requirements and ensure you comply
with all laws.
NOTE:
If have a filter pump, refer to the pump's manual for
instructions.
NOTE:
The ladder must match the pool size and should to be used
only for entering and exiting the pool. It is forbidden to exceed the permitted
payload of the ladder. Check regularly if the ladder is properly assembled.
Installation
Bestway Inflatables will not be responsible for damage caused to the pool due
to mishandling or failure to follow these instructions.
1. Lay out all parts and check that you have the correct quantities as listed in
the components list. For assistance or FAQs, please visit the support
section on our website, www.bestwaycorp.com.
2. Spread out the pool and make sure the pool is right side up, let it sit
exposed to direct sunlight for 1 hour or more so that the pool is more
flexible during set up.
3. Place the pool near an adequate drainage system to deal with overflow
water and ensure the pool's inlet A and outlet B are correctly positioned to
allow your filter pump to connect to a power source.
NOTE:
Do not use extension power cords to power your pump.
ATTENTION:
Do not drag the pool on the ground, this can
damage the pool.
1
A
A
A
A
A
A
2
A
C
3
D
F
A
A
A
A
A
A
A
A
A
A
A
C C
C
C
C
C
C
C
4
5
Connection Valve Assembly
For pool with connection valve
A
Filling Pool with Water
ATTENTION:
water.
1. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could
cause the pool to collapse. In times of heavy rainfall you may need to
empty some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not collecting on
any side to ensure the pool is level.
IMPORTANT:
ground by digging out. Never attempt to move the pool with water in it,
serious personal injury or damage to the pool may result.
WARNING:
C
C
your pool has any bulge or uneven side then the pool is not level, the sides
C
may burst and the water may discharge suddenly causing serious personal
C
injury and/or damage to property.
3. Check pool for any leaks at valves or seams, check any evident water loss.
Do not add chemicals until this has been done.
Proper Water Level
11
B
E
1in. - 2in.
2-5 cm
A
Do not leave pool unattended while filling with
If pool is not level, drain water and re-level
Your pool may contain a great deal of pressure. If
0°
B