Display The Operating Parameters - DGFLOW STEADYPRES V2.0 Manuel D'utilisation Et D'entretien

DISPLAY THE OPERATING PARAMETERS

During
operation
Pressing the key
Display
SYSTEM PRESSURE
P 3.2
Displays the system pressure (only for MASTER inverter)
OPERATING FREQUENCY
F 45
Displays the motor revolution Frequency.
ABSORBED CURRENT
A 6.5
Displays the motor absorbed current (RMS value)
CAUTION! Standard ammeter may read input and output current values different
from the one shown by inverter.
DYNAMIC VOLTAGE
V 230
It matches to the power supply 'voltage value' - only with pump in standby.
Power factor (COSFI):
PF .85
Shows the instantaneous value of the power factor
POWER MODULE TEMPERATURE
Tm 50
Displays the inverter's electronic module temperature.
Ti 30
INVERTER BOX INTERNAL TEMP.
Displays the box internal Temperature
Tc 50 INVERTER BOX INTERNAL TEMP.
Displays the box internal Temperature
In 0 INPUT ACTIVATION STATUS
Displays the input signal activation Status
1= enabled input / 0= input not enabled
Ou 0 OUTPUT ACTIVATION STATUS
Displays the output relay activation Status
1= enabled input / 0= input not enabled
STATUS RS 485 (SLAVE connection)
S1-S2
Displays the status of the inverter SLAVE connected to the inverter MASTER.
The parameter is not displayed in applications STAND-ALONE
(parameter W = NC).
XX-XX = no SLAVE inverter connected
S1-XX = inverter SLAVE1 connected
XX-S2 = inverter SLAVE2 connected
S1-S2 = inverter SLAVE1 e SLAVE2 connected
To display the parameters on the
display
Scroll the
parameters
through the
keys
You go back to the system pressure (only
for MASTER inverter)
Description m.u..
bar
Hz
A
V
° C
° C
° C