Starting-Up; Access To Main Menu; Access To Parameters - DGFLOW STEADYPRES V2.0 Manuel D'utilisation Et D'entretien

Switch on
(the switch is
not present
in models
T/T)
and wait the
STARTING
time (ab. 10
sec.)
To ACCESS the
four main MENU
Press the SET
button for 3 sec.
BASIC MENU
parameters
BASIC
ADVANCED MENU
parameters
ADV
INSPECTION MENU
parameters
INSP
TEST
mode
TEST
(only in
OFF
mode)
To SCROLL the
parameters
use the buttons
STARTING UP

ACCESS TO MAIN MENU

MAIN MENU
BASIC PARAMETERS for the configuration of the drive.
ADVANCED PARAMETERS for the detailed configuration of
the drive.
INSPECTION PARAMETERS, display the hours of work, the
number of starts, alarm history, etc..
TEST mode allows you to start and stop the pump in manual mode (START
/ STOP button) and change the frequency in steps of 1 Hz.
It also allows to control the operating parameters of the motor and inverter.
WARNING: DURING MANUAL OPERATION, AUTOMATIC CONTROLS
ARE EXCLUDED, AND THE OPERATOR MUST AVOID ANY
INCORRECT OPERATION.

ACCESS TO PARAMETERS

By pressing
the button
START
STOP
you put
the inverter.
To SCROLL the 4
MAIN MENU
use the buttons
To ACCESS and
EXIT the MAIN
MENU
use the buttons
To ENTER and EXIT
the parameters
use the buttons
To MODIFY the
parameters
use the buttons