Part 1 - Quick Installation Guide; Preliminary Checks; Control Panel; Installation And Hydraulic Connections - DGFLOW STEADYPRES V2.0 Manuel D'utilisation Et D'entretien

PART 1 - QUICK INSTALLATION GUIDE

During the initial installation and maintenance, make sure that
live.
During the initial installation and maintenance, make sure that the system is not under
pressure
to ACCESS THE DRIVE WIRING, open the front cover as shown on p. 5
DO NOT OPEN INVERTER COVERS, except for the connector cover
Models T / T (three-phase IN / three-phase OUT) do not have the switch on board, for these
models the inverter supply line must be protected in accordance with the regulations
- Install the inverter in a place:
o protected from the elements
ventilated, free from excessive humidity or excessive dust
o
o as close as possible to the pump
o make sure that does not receive harmful vibrations or mechanical stress from connected
pipelines

- Control panel:

1 2 3

INSTALLATION AND HYDRAULIC CONNECTIONS

OUT
OK
IN
NO SEALING
NO CANAPA
NO TEFLON

PRELIMINARY CHECKS

4 5
Install in a
vertical
position
Do not use
O-RING
sealant in the
three-pieces
joint; are
already
equipped
O-RING
with O-Ring
ends of the line wires are not
1- START/STOP button
7
2- Red LED (power)
3- Green LED (status)
4- Display
5- SET button
6- Confirm button
7-
Scrolling UP / DOWN
/
RIGHT / LEFT
6
Do not install
NO
in a horizontal
position
The freezing of the
liquid contained in the
inverter body causes
irreversible damage
to the inverter