MTD 490-241-0032 Instructions De Montage page 8

17. Fully insert the ends of the front of the cab assembly
into the ends of the crossbar (J). Insert set screws (S)
into ends of crossbar (J). With assistant holding cab
assembly horizontal to the ground, tighten all bolts and
set screws.
CAUTION: Do not overtighten the set screws.
18. Finish assembly by fastening all hook-and-loop straps
inside the cab if you have not already done so.
CAUTION: No cab fabric should be allowed to touch engine
or exhaust.
19. The cab is designed to accommodate snow throwers
equipped with a light. A zipper on the front of the cab
can be opened and the fl ap pulled back to allow the
light to shine through. At this time, adjustments may be
necessary for free movement of operation controls.
20. For storage, loosen the two set screws (S) in crossbar "J" and pull the cab up and out of crossbar "J." See Figure 17.
21. For cleaning, just use mild soap and water.
8
S
J