MTD 490-241-0032 Instructions De Montage page 4

4. Insert poles G, narrow end up, into A end of both A/B
assemblies. Insert set screw (S) into top of bars A,
securing in fi nger-tight.
5. Place curved bar C on fl at surface, nuts facing up.
Insert the labeled end of curved bar D into C (making
sure arrows meet). Repeat with the other bar D on the
opposite end of bar C. Insert set screw (S) into ends of
bars C, securing in fi nger-tight.
6. Place assembly D/C/D onto ends of poles G. Insert
set screw (S) at the bottom of poles D, securing in
fi nger-tight.
7. Make sure cab frame is in the shape of a box, with
right angles (90°). Then tighten all the set screws (S),
except the set screws (S) on the crossbar (J), using the
enclosed Allen wrench.
CAUTION: Do not over tighten the set screws.
4
B
G
S
A
Back
S
S
D
D
C
F
S
B
G
Back
F
F
Front
J
G
B
A
S
C
D
Front
D
F
J
S
90°
90°
G
B