Witter R47U Mode D'emploi

MATERIALS
A 1 Cross Bar
B 1 Bracket
C 4 Angle Bracket
D 1 Bracket
E 4 M12 x 40 x 1.75 thread forming bolts, lock washers, and flat washers
F 4 M12 x 35 x 1.75 bolts, lock washers, and Nuts
G 8 M12 x 35 x 1.75 bolts, lock washers, and Nuts
H 2 M12 x 40 x 1.75 thread forming bolts, and lock washers
ZE 1 Retractable electrical plate kit (including fitting instruction)
ZN 1 Detachable Neck Kit
X 10 Existing M12 Bolts with integral washer
FITTING
1. Remove each rear light cluster by prising out the black plastic cover alongside the tailgate opening to expose the two
securing screws.
2. Remove black plastic Under Tray. (4 screws)
3. Remove bumper. (2 screws & 2 clips in wheel arch; 2 screws top edge behind tailgate; screws along bottom edge)
4. Remove crash beam and retain the fixing Bolts (X).
5. Assemble Cross Bar (A) to the vehicle rear panel using existing fixing Bolts (X), taking car not to pinch cabling between
Cross Bar and vehicle – unclip and relocate cables if required. Remember to relocate the exhaust support brackets to the
bottom mounting point on each side.
6. Loosely assemble Brackets (B & D) to Cross Bar (A) and under-side of vehicle, using fasteners (F & H).
7. Loosely attach Angle Brackets (C) to Brackets (B & D) and under-side of vehicle using fasteners (E & G).
8. Assemble Detachable Neck Kit (ZN and Retractable Electrical Plate (ZE) to Cross Bar (A) using fasteners and instructions
from the appropriate kits.
9. Fully Tighten all Fasteners.
10. Re-fit the bumper.
11. Trim the black plastic under-tray to clear the Brackets (B & D) and refit to underside of vehicle.
12. Re-fit the removable Bumper Cover Plate
Bumper Cover Plate Options
The Range Rover Sport has a removable centre panel (2 – quarter-turn screws) which in most cases is the preferred
solution for covering the tow bar after use. However, a replacement panel is available which allows access to the tow
bar without removing the normal panel and exposing the structure of the vehicle. The replacement panel can be ordered
from Land Rover Dealerships:
VPLWB0135 – Techno Silver (Metallic)
VPLWB0138 – Santorini Black (Gloss Black)
VPLWB0140 – Indus Silver (Non-Metallic)
Recommended torque settings:
Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200 Nm
M12 – 120Nm, M10 – 70Nm M8- 35Nm
Grade 10.9:
Fitting
Instructions
µW0001R47U-FIT$010802220000bÄ
W0001R47U-FIT$010802220000
TOWBAR
For Range Rover Sport
2014-
R47U