Witter R44U Instructions De Montage

MATERIALS
A 1 Cross Bar with European facing to 94/20/EC A50-1
B 1 Bent Rear Panel Profile
C 1 Bent Chassis Profile Left
D 1 Bent Profile Right
E 2 M14 x 100 x 2.0mm pitch Bolts, Lock Washers and Flat Washers
F 3 M12 x 45 x 1.75mm pitch Bolts, Lock Washer and Flat Washers (Dia. 25mm)
G 2 M12 x 45 x 1.75mm pitch Bolts, Nyloc Nuts, and Flat Washers (Dia. 25mm)
H 2 M12 x 45 x 1.75mm pitch Bolts, Nyloc Nuts, and Flat Washers (Dia. 25mm)
J 1 Electrical Plate Angle (ZEQ5)
K 1 Electrical Plate KIT (Z99)
ZF 1 Approved neck ZF combination Illustrated
FITTING
1. From underside of vehicle lower rear exhaust silencer by removing 3 exhaust rubbers from hangers. On the forward
exhaust section lower exhaust hanger and undo exhaust clamp then pulling system off If required.
2. Remove Heat shield inside of bumper by undoing bolts top, middle and bottom. Slide away, caution sharp edges.
Note: Refit the inside bumper fixing bolts as towbar will impede these.
3. Loosely assemble Side Bracket (C) to left chassis rail using forward fastener (E).
4. Remove two existing M8 nuts (X) (with captive washers) from studs located on the rear crash beam panel left side.
Slide bracket (B) over the studs using original nuts. Align hole with bracket (C) and tighten the remaining fixing (E).
5. Assemble bracket (D) to crossbar (A) as shown using fixings (G) and remaining existing fastener (X).
Note: It may be necessary to trim away some of the internal bumper plastic above the exhaust tail pipe to fit
Bracket (D) over the stud (X). First remove the towing eye cover to gain access before trimming.
6. Assemble Cross Bar (A) to Side Bracket (C) and to the three holes on the vehicle towing eye (ensure threads are
clean of paint) Use fixings (G), (H) and existing fasteners (X) , ensuring they are fitted as shown.
7. Tighten all fixings to their specified torque and refit exhaust and all fixings.
8. For ease of fit on the ZF and ZS applications trim away bottom flange of bumper as shown. For detachable this will
require a larger cut due to housing.
9. Assemble the preferred Neck Kit and Electrical Plate to Cross Bar (A).
Recommended torque settings:
Grade 8.8 bolts: M8 - 24Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200 Nm
Fitting
Instructions
µW0001R44U-FIT$021110100000eÄ
W0001R44U-FIT$021110100000
TOWBAR
For Range Rover Evoque 2011-
For use with '2034' series necks
R44U
For R44/R44Q/
R44QF & R44S