Publicité
Step 12
IMPORTANT: If you purchased the 418738 Electric Fireplace Converter
å
Kit, do not fasten the CENTER BACK (J) to your unit as shown. You will
only fasten the BACKS (I and K).
Carefully turn your unit over onto its front edges. Lay the UPPER BACK (I)
å
over your unit.
Make equal margins along the top and both side edges of the UPPER
å
BACK (I). Push on opposite corners of your unit if needed to make it "square".
Fasten the top and side edges of the UPPER BACK (I) to your unit using
å
the NAILS (1N).
Fasten the top, bottom, and side edge of each BACK (K) to your unit using the
å
NAILS (1N). The BACKS (K) will overlap the UPPER BACK (I).
Then, fasten the CENTER BACK (J) to your unit. Use twenty-eight BLACK
å
9/16" LARGE HEAD SCREWS (1S). The CENTER BACK (J) will overlap
the BACKS (I and K).
NOTE: Perforations have been provided for access through the BACKS.
å
Carefully cut out the holes needed.
The large holes on the
BACKS (K) must be here.
Page 16
I
K
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
BLACK 9/16" LARGE HEAD SCREW
(28 used for the CENTER BACK)
J
K
419119
1N
NAIL
(52 used in this step)
1S
The large hole on
the UPPER BACK (I)
must be here.
www.sauder.com/services
Publicité
