Radio System Corporation petporte smart flap Mode D'emploi page 7

smart
INSTALLATION DIAGRAMS
Figure 9
Click the small cover plate back over the interior section.
Figure 10b
Alternatively you can hold the Smart Flap in an inverted
orientation for the purpose of programming your cat's
microchip in.
Figure 12
Attach the scanner cable to the circuit board and hold the
exterior and interior sections together using the two M6
screws. Tighten the screws to hold the Smart Flap in the
desired position within the opening.
flap
Figure 10a
Power up the Smart Flap, program in your cat as
shown in the user guide and pass the Smart Flap over
your cat at a distance that your cat would normally
approach it to check that will work for your cat.
Figure 11
When fitting the Smart Flap into an opening offer the
interior section with tunnel extensions if needed up
to the opening. Next pass the scanner cable from the
porch and exterior section through the rectangular
opening in the interior section.
Figure 13
Once positioned, attach the large cover and secure with the
four self-tapping screws. Click in place the small cover. Place all
of the screw covers, four small ones for the self-tapping and
two large ones for the M6. Finally, power up your Smart Flap.
Installation Guide - Page 6