Radio System Corporation petporte smart flap Mode D'emploi page 6

smart
INSTALLATION DIAGRAMS
Figure 3
Attaching the four "horseshoe" clips to the four
"mushrooms" on the underside of the porch.
Figure 5
Pass the scanner cable from the porch and exterior
section through the rectangular opening in the interior
section.
Figure 7
Attach the low voltage power supply connector to the
electronics board and pass the power cable through the
clips and out the opening at the bottom of the interior section.
flap
Figure 4
Remove the extension tunnel from the interior
section. Loosen the four self-tapping screws from the
interior section and remove the large cover plate.
Figure 6
Temporarily attach the porch and exterior section to
the interior section with the two M6 screws. Attach
the scanner cable to the electronics board as shown.
Figure 8
Replace the large cover to the interior section and
temporarily secure with the four self-tapping screws.
Installation Guide - Page 5