Installation Diagrams - Radio System Corporation petporte smart flap Mode D'emploi

smart
SMART FLAP INSTALLATION INTO GLASS DOORS OR WINDOWS
The Smart Flap is also designed for installation into glass and requires a circular hole of diameter 212 mm. Working with glass is a skilled
job and should be carried out by a professional glazier. Your glazier will need to cut a circular hole of diameter 212mm as per the glass
template. If you are in any doubt then please consult with your glazier about the fitting of the Smart Flap. Once a suitable opening is
formed then fit as described for a non-glass door missing sections v) to viii).
SMART FLAP INSTALLATION INTO A WALL
It is also possible to install a Smart Flap into a wall. You must only fit a wall model to a wall because it has specialist features to enable this.
The forming of openings in walls requires specialist advice from qualified architects.

INSTALLATION DIAGRAMS

Figure 1
Pass the scanner coil cable from the porch
through the small rectangular opening in the
exterior section.
flap
Figure 2
Pass the four "mushrooms" pins through the
back of the exterior section into the porch
Installation Guide - Page 4