Solar PI1500X Mode D'emploi page 9

Note: Your power inverter is equipped with a cooling fan, which is
designed to run continuously when the inverter is in use. Automatic
shut down caused by high circuit temperature will occur when the
cooling fan is unable to maintain a cool enough temperature for safe
operation of the power inverter.
In the event the automatic shut down protection occurs turn
inverter immediately. Do not re-start the power inverter until the source of the
problem has been identified and corrected.
SOLAR Power Inverter Maintenance – Replacing Blown fuses
Your SOLAR power inverter is equipped with fuses of specific amperage
rating and physical design. In most cases, the fuses should not need to be
replaced. If you require replacement fuses, it is important that you purchase
and install the correct replacement fuse(s). Please reference the chart below
to determine the correct fuse(s) for your product.
Model No.
PI1500X
ALWAYS disconnect your SOLAR power inverter from the 12 Volt power
source prior to attempting to replace the fuse(s). ALWAYS use the proper
replacement fuse(s) as indicated in the chart above. Make sure to address
the root source of the overload that caused the blown fuse prior to using
your power inverter again.
No. of Fuses
1
Fuse Rating
15 Amp
the power
off
Fuse Type
Spade Type