Important Safety Instructions - Solar PI1500X Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

Never open the inverter case – severe shock hazard!
Your power inverter is designed to operate from a 12 Volt DC power source
only. NEVER attempt to connect your SOLAR power inverter to any other
power source, including any AC power source.
Your power inverter is designed to be connected to the 12 Volt power source
using the connection cables provided. Do not attempt to modify the provided
connection cables or use other means of connecting to the 12 Volt power
source.
Do not operate the SOLAR power inverter in the vicinity of flammables, such
as gasoline, etc. Do not operate the inverter in areas where fumes or gases
may accumulate, such as battery compartments.
Do not operate the power inverter if you, the inverter, the device being
powered or any other surfaces that may come into contact with the 12 Volt
power source are wet. Do not expose your power inverter to rain or moisture.
Keep your SOLAR power inverter well ventilated when in operation. Avoid
placing the power inverter near sources of heat, such as heat vents and
radiators, or in direct sunlight.
Loose connections can result in a severe decrease in voltage, and may
cause damage to the wires and insulation in the power inverter. Always
check that all connections are correct and secure prior to powering the
inverter or any device connected to it.
When connecting device/appliance power cords to the inverter, pull on the
plug and never on the wire when disconnecting. Do not operate a device/
appliance with a damaged power cord.
To avoid battery drain, always disconnect your SOLAR power inverter when
not in use.