Solar Power Inverter Safety Features - Solar PI1500X Mode D'emploi

1. Make sure the television/audio antenna on the device produces a
clear signal under normal operating conditions (when plugged into a
standard 110 Volt AC outlet). Also, ensure that the antenna is properly
shielded and of good quality.
2. Change the positions of the power inverter, antenna, and tv/audio
power cord to see if a change of their relative positions improves your
reception.
3. Isolate the television/audio device, its power cord and antenna cables
from the power inverter and 12 Volt power source by running an
extension cord from the television/audio device power cord to the
inverter.
4. Coil the television power cord and the power cables running from the
12 Volt power source to the power inverter.
5. Attach a "Ferrite Data Line Filter", available at most electronic supply
stores, to the television/audio device power cord. More than one filter
may be required.

SOLAR Power Inverter Safety Features

Your SOLAR power inverter is equipped with automatic shut off protection
which will be activated if any of several unsafe operating conditions exist. In
the event that any of the following conditions occurs, the power inverter will
shut down:
1. The power input from the 12 Volt power source drops to 9.5 Volts.
2. The power input from the 12 Volt power source exceeds 15.5 Volts.
3. The "continuous power" demand from the powered device exceeds
the continuous power rating of your power inverter.
4. The "peak power" demand from the powered device exceeds the peak
power rating of your power inverter.
5. The circuit temperature within the power inverter exceeds 165˚F.