Hoover H-PURIFIER 300 Notice D'utilisation page 10

GB
ALERTS & SOLUTIONS
The following codes may appear during using. [Fig. 16]
Fig. 16
Error Description
Outer Layer's Filter
cleaning Alert
Filter replacement
Alert
Filter not present or
filter has not been
locked
Dust sensor
malfunctioning: no
signal from sensor or
output voltage exceeds
the limit value
Motor no speed
CO sensor
malfunctioning
ATTENTION: If any of these failures persist, contact your local Hoover representative. DO NOT try to disassemble the H-Purifier by yourself.
TROUBLESHOOTING
The following is a list of commonly encountered problems and solutions.
If any of these problems persist contact your local Hoover representative.
The Fan does not work
(Control Panel / Display
Lights on)
The Fan does not work
(Control Panel / Display
Lights off)
No Lights on Control Panel /
Display (Fan Working)
Buttons on the control panel
/ Display do not operate
Air Flow is Weak
Air Purifier is operating
loudly
Air Purifier makes a loud
buzzer sound all of a
sudden.
10
Error Description
Alert on product Control
Panel / Display
Filter Cleaning button turns
yellow
Filter Cleaning button turns
yellow
Filter Cleaning button and Filter
Replacement button blink
/
/
CO sensor status lamp is on in
yellow
• Check the alert showing on the display or in the app.
• Check if there are any obstructions in the fan.
• Check if the H-Purifier is switched on.
• Check if the filter is incorrectly installed and locked.
• The Air Purifier may be in the ECO mode due to the good air quality. See "AUTO MODE [Fig. 6]"
• Check if the H-Purifier is plugged in and switched on.
• Check if there are any obstructions in the fan.
• Check if the lights have not been switched off by pressing the Light Control button on the control Panel
/ Display.
• Check if Child lock has been activated by pressing and holding the Child Lock Button for 3 secs.
• Check if the protective packaging has been removed from the filter.
• Check if there are any obstructions in the Air Intake Cover or Air outlet.
• Check the Filter staus on the Control Panel / Display or in App for clean or replace warning.
• Check if the H-Purifier is in sleep mode. The fan operates on reduced power in this mode.
• Check if there are any obstructions in the Air Outlet or the fan.
• Check if the H-Purifier is running in MAX mode, the air flow is at maximum power in this mode.
• The testing function of CO Alert button is activated by mis-operation. The sound will automatically stop
after 5 seconds.
Alert on APP
1.Follow the instructions in I/M to clean the Outer
Filter cleaning Alert Layer's Filter.
2.Reset the alert.
1.Follow the instructions in I/M to replace the filter.
Filter replacement Alert
2.Reset the alert.
1.If filter is not present, put it back.
Filter not present or filter has
2.If filter is in position, check whether the Filter
not been locked
Tab has been switched to LOCK status.
Dust sensor malfunctioning: no Dust sensor failure or dust sensor wire has not
signal from sensor or output been connected well, please call service center
voltage exceeds the limit value to fix.
Motor failure or motor wire has not been
Motor no speed feedback
connected well, please call service center to fix.
CO sensor malfunctioning Alert: need call service.
Error Solution