Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite Round Retrofit Kit
®
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
REMOVING UN-NEEDED PARTS (FIG. 1)
1. Shut off the power at the circuit breaker. Remove diffuser, old sockets and
lead wires, retain all other parts including the crossbar.
2. Twist the ceiling pan (D), to loosen and remove via the key hole slots.
You should have access to the junction box now.
3. Carefully unpack your new retrofit kit and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
INSTALLATION STEPS:
4. Route LED retrofit kit wire harness wires (1 white, 1 black) and ground wire
(1 green) through wire opening in fixture. Confirm wires will not be pinched by
round LED mounting plate or other fixture hardware when reassembled.
5. Secure the retrofit to the fixture using one of the three installation options
available for retrofitting:
A-Dome Installation
6. Connect wire harness leads to mains wiring inside junction
box using (3) wire nuts/connectors (WAGO)
a. Green wire to ground wire (bare or green)
b. Black or blue wire to line conductor (black)
c. White wire to neutral conductor (white)
7. Place the provided label in the outer space of the luminaire
after the LED engine installation has been completed. Label
must be visible.
THIS LUMINAIRE HAS BEEN MODIFIED TO OPERATE
LED LAMPS. DO NOT ATTEMPT TO INSTALL OR OPERATE
FLUORESCENT LAMPS IN THIS LUMINAIRE.
8. Re-attach and secure the lens to luminaire. (Luminaire will work with or without diffuser)
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
B-Junction Box Installation
Secure light engine with
supplied hexnut
Secure plate and light
engine together through
these 2 holes with 2pcs
existing or supplied
machine screws, twist
& lock.
(+) LINE
(-) COMMON
GROUND
FRK Series
C-Surface mounting
Use a power drill to fix light engine
with supplied 4pcs self-tapping
screws.
Mark the positions of the 4 drill
holes on the plate before drilling.
BLACK
WHITE
GREEN
Page: 2
REV: 09/08/22
OUTLET BOX
(CEILING)
Light
Fixture
Publicité
Table des Matières
