Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite Enclosed High Bay Retrofit Lamp
®
Installation Instructions
1.
Turn off the power before installation.
2.
Remove the old ballast, capacitor and ignitor (if existing). (Figure 1).
3.
directly. (Reattach or replace ground lead if one is needed). (Figure 2).
Make sure the alternating current wires connect to the E39 or EX39 socket
4.
luminaire. (Figure 3).
Screw the LED lamp into the corresponding socket. Attach retrofit label to
5.
(Figure 4).
Use safety rope to secure lamp and prevent it from falling due to old socket.
Sensor Addons (sold separately)
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
High Bay Retrofit Lamp - Type B Series
Safety rope
4
Page: 2
REV: 10/09/20
Publicité
