Included In Delivery - Thermador TCM24PS Mode D'emploi

A
IMPORTANT SAFETY PRECAUTIONS
READ AND SAVE THESE INSTRUCTIONS
¡
CAUTION
To avoid the risk of suffocation:
Do not allow children to play with packaging material. Store
small parts safely as they can be a choke hazard.
To avoid the risk of injury:
Do not reach into the grinding unit. Be careful not to close the
door on your fingers. This can result in injury.
Unpacking and Moving the Coffeemaker
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least two
people must be used in moving the coffee-
maker to avoid injury and to avoid damage to the unit or the
floor.
Rings, watches, and any other loose items that may damage
the unit or otherwise might become entangled with the unit
should be removed.
Hidden surfaces may have sharp edges. Use caution when
reaching behind or under appliance.
To avoid the risk of effecting electronic implants:
Hazard due to magnetism
The appliance contains permanent magnets which may affect
electronic implants, e.g. heart pacemakers or insulin pumps.
Persons wearing electronic implants must maintain a
minimum distance of 4" (10 cm) from the appliance and from
the following parts upon removal: milk container, milk system,
water tank and brewing unit.

Included in delivery

a Fully automatic coffee machine
b Installation instructions
c Assembly bracket
d Transformer mount
e Spacers
f 7 fastening screws (silver)
g 2 fastening screws (long/black)
h 1 sleeve (black)
i 2 fastening screws (short/black)
j 2 sleeves (white)
k Transformer
l Hose guide
m Hose clamp
n Adapter
o Hose clamp for adapter
10 – en
¡
WARNING
All units and systems used to deliver the water to the coffee
system must conform with requirements of local building and
safety codes.
– The fixed water connection should be installed only by
a qualified technician.
– Do not connect the appliance to a hot water connection.
– Connect the appliance to a cold water connection (fresh
water supply).
– Fresh water supply must be used.
– The water supply must withstand the operating pressure.
– The water pressure must be between 0.05 MPa (0.5 bar)
and 1 MPa (10 bar). If the water pressure is higher than
this, a pressure-reducing valve must be installed upstream.
– The hygiene regulations must be observed during installa-
tion and operation.
– The machine must be connected to the water supply in
accordance with local and national regulations.
– Do not mount directly above a sink or connect directly to the
sink. Properly follow installation instructions to connect
water intake and/or drain (as applicable).
General information for water and
drain water connection
The appliance should not be installed more than 393/8"
(1000 mm) away from a drain water connection. The water
connection can be extended by 1187/64" (3000 mm) with a
special pipe (part number 00357081).
A shut-off valve must be installed between the water inlet hose
and the domestic water connection so that the water supply
can be turned off if necessary. The shut-off valve must be freely
accessible following installation.
The appliance complies with the international standards and
may not be connected without a backflow preventer.
A tap with a 11/16" (26.4 mm) screwed connection is required for
connection. If not available, the appliance may be connected
only by an approved technician.
The water quality must comply with the drinking water regu-
lations of the individual country in which the appliance is
operated.
The connection to the domestic water supply and all equipment
and devices used to supply the water to the appliance must
comply with the applicable provisions of the individual country.
The drain water connection must be min. 5
below the lower edge of the appliance.
The drain water hose must not be extended.
If the installation location of the appliance is too far away
from the main drainage point (siphon), the drainage system
(domestic installation) must be adapted.
/ " (min. 150 mm)
29
32