Installing The Batteries To The Remote; Connect Power & A Ntenna/Cable/Satellite; Switching On/Off; First Time Installation - Telefunken L32H125A3 Mode D'emploi

Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. I nstall t wo A AA b atteries. M ake s ure t o m atch t he +
and -­ e nds o f t he b atteries i n t he b attery c ompartment
(observe the correct polarity.
3.
Connect P ower & A ntenna/Cable/Satellite
IMPORTANT: The TV set is designed to operate on
220-­240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
13V dc /18V dc
VGA
SPDIF
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-­240V A C, 50 Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the " " button, P+ / P-­ or a numeric button on
the remote control.
Press t he c ontrol s witch l ocated o n t he l eft s ide o f t he
TV. The TV will then switch on.
To Switch the TV Off
Press t he " " b utton o n t he r emote c ontrol o r p ress a nd
hold the control switch on the TV, so the TV will switch
to standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Satellite
Aerial or Cable
DiSEqC
Switch
English -­ 38 -­
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active. The LED can also blink when you switch on
the TV from standby mode.
First Time Installation
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the " " or "
language, press OK button to select. "First Time
Installation" appears. Use " " or " " button to set
the required country, and press "
Search Type (Optional). Use" " or " " to set the
desired search type. A vailable search types are Digital
and analog, digital only and analog only. When set,
press " " t o s elect T eletext L anguage. U se " " o r "
" b utton t o s et t he " Teletext L anguage" a nd s elect " Scan
Encrypted" u sing " " o r "
Encrypted as Yes if you want to scan coded stations.
Default PIN code can change depending on the
selected c ountry. I f y ou a re a sked t o e nter a P IN c ode
for viewing a menu option, use one of the following
codes: 4725, 0000 or 1234.
Press OK button on the remote control to continue and
the f ollowing message will be displayed on the screen.
" button to highlight the required
" button to select
" b utton. Y ou c an s et S can