NewAge Products Pro 3.0 Serie Guide D'installation page 26

Masquer les pouces Voir aussi pour Pro 3.0 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Mounting the Fan onto Lockers (Optional)
Warning
Fan installation is optional and any of the fan components are not included in the package. Such fan
can only be installed onto Pro 42" and Pro 48" Extended Lockers.
DO NOT stand inside the locker during fan installation.
Its customer's responsibility that the fan installation meet the National Electrical Code.
Customer has to purchase aftermarket fan. 90mm to 120mm width (3.5in to 4.72in) are the recommended
fan sizes. Please refer to the minimum and maximum W X H hole locations on the fan to ensure fans are
compatible.
Refer to the mounting hole diameter below. The outer diameter of the Bolts should be 0.2 in/ 5.08 mm or
smaller.
TOP VIEW
Mounting Hole
Diameter
0.2 in, 5.08 mm
Parts Required.
Fan Assembly x2
Pro Series 3.0
Extension
Lockers
Fan Guard x2
(42", 48")
(RECOMMENDED)
26
Bolt and Nut
Assembly x8
Grommet x1
Filter x2
4.38 in, 111.4 mm
3.19 in, 81.1 mm
Using the pre-defined hole location on
1
locker, create an opening to feed the wires
that are provided with the fan assembly.

Publicité

Table des Matières
loading

Table des Matières