Accessories; Preparation Before Installation - Daikin BYFQ60C3W1W Instructions

BYFQ60C3W1W
BYFQ60C3W1S
The English text is the original instruction. Other languages
are translations of the original instructions.
Read this manual attentively before installation. Do not throw
it away. Keep it in your files for future reference.
Improper installation or attachment of equipment or
accessories could result in electric shock, short-circuit,
leaks, fire or other damage to the equipment. Be sure only to
use accessories made by Daikin that are specifically
designed for the use with the equipment and have them
installed by a professional.
If unsure of installation procedures or use, always contact
your dealer for advice and information.
Before installation
„ Leave the unit inside its packaging until you reach the installation
site.
Rotary fan
Cut off the main power before opening the grille.
„ Refer to the installation manual of the indoor unit for items not
described in this manual.
NOTE To the installer
Be sure to instruct the customer how to properly
operate the system showing him or her the operation
manual of the indoor unit.

Accessories

Installation manual
Screws (4x)
Grille hinge (2x)

Preparation before installation

For this unit, you are able to select airflow directions. To discharge air
in 2 or 3 directions, it is necessary to purchase the optional blocking
pad kit for sealing air discharge outlets.
Handling of the decoration panel
To prevent any damage to the decoration panel, take care of the
following:
- Never place the decoration panel facing down.
- Never let the decoration panel lean against a wall.
- Never place the decoration panel on a sharp or projecting
object.
- Never touch or put pressure on the swing flap in order to
prevent malfunction of the swing flap.
English
Decoration panel
Preparing the decoration panel for installation
1 Remove the suction grille from the decoration panel.
1 Decoration panel
2 Suction grille
3 Lever
„ Remove the transporting tape from the decoration panel suction
grille and flaps.
„ Push the suction grille lever (3) inward and open the suction grille
(2). (See figure 1)
„ Detach the suction grille from the decoration panel by lifting the
suction grille up approximately 90 degrees (A) until the position is
reached on which removal of the suction grille is possible (B).
(See figure 2)
Installation of the decoration panel to the
indoor unit
Refer to the installation manual of the indoor unit for details on
installing the indoor unit.
1 Install the decoration panel (See figure 3)
1 Temporary latch
2 Hook
3 Swing flap motor lead wire
4 Piping area
5 Piping side mark
6 Drain area
7 Drain side mark
1 Hold the decoration panel against the indoor unit by matching the
piping side and drain side marks on the decoration panel with the
position of the piping area and drain area of the indoor unit.
2 Turn 2 panel temporary latches up into the hooks of the indoor
unit so the decoration panel is temporarily fixed to the indoor unit.
(See figure 3)
3 Make sure that the swing flap motor lead wire isn't caught
between the decoration panel and the indoor unit.
4 Attach 4 supplied screws and check whether the decoration
panel is properly aligned with the indoor unit and ceiling.
5 Tighten all 4 screws until the thickness between of the sealing
material between the decoration panel and the indoor unit
reduces to 0.16-0.31 in. (4-8 mm). (See figure 4)
1 Indoor unit
2 Ceiling
3 Sealing material
4 Decoration panel
5 Air outlet
Installation manual
1